A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
-
Measure distance - a - between two studs in selector mechanism.
^
Specification: distance a = 85 mm
Note:
^
Measure from center of one stud to center of the other.
-
If distance measured is not correct, adjust dimension - a - as follows:
-
Loosen bolt - arrow - for push rod.
^
Rear push rod (in selector mechanism) must move freely in both directions on slide.
-
Set to distance - a - by moving rear push rod (in selector mechanism).
-
Tighten bolt for push rod - arrow - to 23 Nm.
-
Loosen bolt for selector rod - arrow -.
^
Connection between selector rod and selector mechanism should move freely.
Align gear lever as follows:
-
Position bottom of gear lever in center of ball guide.
^
Distance between ball guide and bottom of gear lever - arrows - must be equal at all points.
-
Align gear lever so that it points slightly (1.50) to the right (as seen in direction of travel).
-
Hold gear lever in this position.