Brake Pedal and Brake Booster - Disconnecting and Connecting
-
Disconnect electrical connector to footwell vent - C -.
-
Remove footwell vents - A- and -B -.
-
Remove brake lamp sensor => [ Brake Lamp Sensor ] See: Power Brake Assist/Brake Intervention Sensor / Switch/Service and Repair.
-
Disconnect electrical connector from the gas pedal module.
-
Disconnect brake pedal from brake booster => [ Brake Pedal and Brake Booster, Disconnecting and Connecting ] See: Brake Pedal and Brake
Booster, Disconnecting and Connecting.
CAUTION!
The brake pedal stop must always be installed. The brake lamp sensor mount could break when the brake pedal is unlocked.
-
Remove tower brace.
-
Remove plenum chamber bulkhead