A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› The camera visual area on the inside of the window must not be covered with condensation or dirty. If it is, clean the visual window by hand using
a cleaning solution.
‹› If the directional stabilization assistance control module (J759) is replaced, the camera and the control module must be re-calibrated. Refer to => [
Lane Assist Calibration Procedure ] See: Alignment/Service and Repair/Procedures/Lane Assist Calibration Procedure.