A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
/Page-2474007.png)
-
Position the circuit board - 4 - for the seat occupied sensor - 2 - in the opening - 3 - in the seat cushion - 1 -.
-
Align the seat occupied sensor - 2 - on the seat upholstery - 1 - according to the markings - arrows -.
CAUTION!
The new seat occupied sensor should be installed in the same location on the seat upholstery as the old seat occupied sensor.
-
Remove the protective film and bond the seat occupied sensor - 2 - firmly to the upholstery - 1 -.
Procedure for all seat versions:
Installation is performed in reverse order of removal, noting the following:
‹› Make sure the seat occupied sensor is not covered by the seat heater element heating coils.
‹› Ensure that electrical connections are pushed in as far as stop and engage with a click.
CAUTION!
Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly,
they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-
Disconnect the battery ground wire with the ignition switched on.
‹› If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.
