A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
‹› Free up wrapped wiring harnesses carefully.
-
If necessary, removing the wiring harness wrapping using a knife.
-
Route yellow repair wire next to damaged wiring harness and cut repair wire to the required length using wire stripper ( VAS 1978/3).
-
Cut damaged wire section from the vehicle-specific single wire.
-
Adjust the sliding stop in the Wire Stripper ( VAS 1978/3) pliers jaws to 6 to 7 mm for the wire to be stripped.
-
Insert the vehicle-specific single wire end from the front into the pliers jaws as far as the stop and squeeze the pliers together completely.
-
Open pliers again and remove the stripped wire end.
-
Repeat the procedure on the other end of the vehicle-specific individual wire.
-
For the repair, use two suitable crimp connectors form the Wiring Harness Repair Set (VAS 1978A).
-
Use the Crimping Pliers (Base Tool) (VAS 1978/1-2 ) to press the crimp connector.