A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
-
Release and remove the connector - 2 -.
-
Seal the power steering pump and line connections using clean sealing plugs.
-
Remove the two bolts - 1 - for mounting the power steering pump from the front.
-
Drive the sleeve - 2 - for the bolt - 3 - in the bracket back slightly to install the power steering pump.
-
Remove the power steering pump.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
Tightening specifications: Refer to => [ Power Steering Pump, with Dynamic Steering ].
‹› Replace seals and gaskets.
‹› Before installing the new power steering pump on the intake side, fill the hydraulic oil and install it by hand until oil drains out on the high
pressure side.
‹› Secure all hose connections with new hose clamps.
-
Note the installation position of the intake hose on the power steering pump.
-
Note the installation dimension of the clamp. Dimension - a - must be 4 mm.