A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Rear Subframe: Service and Repair
Rear Suspension
All Wheel Drive
Subframes, Stabilizer Bar and Coupling Rod, Assembly Overview
1
Clamp
‹› Replaced together with the rubber bushing and stabilizer bar.
‹› The rubber bushing and clamp must not be separated from the stabilizer bar.
2
Bolt, 25 Nm +90°
‹› Always replace after removal.
‹› Tighten evenly.
3
Bolt, 40 Nm +90°
‹› Always replace after removal.
‹› Must be tightened in the curb weight position. Refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position ] See: Wheel
Bearing/Service and Repair/Procedures/Rear Suspension.
4
Bolt, 40 Nm +90°
‹› Always replace after removal.