A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
-
Tighten the threaded connection - 1 -.
-
Install the brake disc and caliper.
-
Tighten the drive axle to wheel hub threaded connection. Refer to => [ Threaded Connection Between Drive Axle and Wheel Hub, Loosening and
Tightening ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Constant Velocity Joint/Service and
Repair/Removal and Replacement.
-
On vehicles with automatic headlamp range control system, perform basic setting of headlamps. Refer to => [ Headlamps ] See: Lighting and
Horns/Headlamp
-
If the vehicle level sensor was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the
control position must be reprogrammed. Refer to => [ Control Position, Programing with VAS 5051B ] See: Suspension Control ( Automatic -
Electronic )/Testing and Inspection..
-
If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module ( J759) must be
re-calibrated. Refer to => [ Lane Assist Calibration Procedure ] See: Alignment/Service and Repair/Procedures/Lane Assist Calibration Procedure.
-
Tighten wheel.
-
Alignment is required, see Table. Refer to => [ Determining if Wheel Alignment is Necessary ] See: Alignment/Service and
Repair/Procedures/Determining if Wheel Alignment is Necessary.