A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Wheel Bearing: Removal and Replacement
Wheel Bearing Housing and Wheel Bearing Unit Assembly Overview
Wheel Bearing Housing and Wheel Bearing Unit Assembly Overview
1
Nut, 40 Nm
‹› Always replace after removal.
2
Upper Front Control Arm
3
Upper Rear Control Arm
4
Bolt
‹› Always replace after removal.
5
Washer
6
Wheel Bearing Housing
‹› Removing and installing, refer to => [ Wheel Bearing Housing ] See: Wheel Bearing Housing.
CAUTION!
When exchanging the wheel bearing housing, make sure the length of the thread on the tie rod end is sufficient (there must be
approximately 5 mm extra thread). If this is not the case, then install a new tie rod end with a longer thread pin.
7
Brake Shield