A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
/Page-2165002.png)
6
Eccentric Washer
7
Bolt
8
Bracket
‹› For the brake hose, brake caliper wiring harness and rear wheel speed sensor wiring harness.
9
Bolt, 10 Nm
10
Rear ABS Wheel Speed Sensor
11
Bolt, 9 Nm
12
Bonded Rubber Bushing
‹› Cannot be replaced separately.
13
Ball Bearing
CAUTION!
‹› Avoid contaminating with dirt and damaging the seal when setting down/storing => [ Avoid contaminating with dirt and damaging
the
seal when setting down/storing. ]
‹› Wheel bearing unit, removing and installing, refer to => [ Wheel Bearing Unit ] See: Wheel Bearing Unit
‹› Wheel bearing unit, servicing, refer to => [ Wheel Bearing Unit, AWD, Servicing ] See: Overhaul/Rear Suspension.
14
Wheel Hub
CAUTION!
‹› Avoid contaminating with dirt and damaging the seal when setting down/storing. Refer to => [ Avoid contaminating with dirt and
damaging the seal when setting down/storing. ]
‹› Wheel bearing unit, removing and installing, refer to => [ Wheel Bearing Unit ] See: Wheel Bearing Unit
‹› Wheel bearing unit, servicing, refer to => [ Wheel Bearing Unit, AWD, Servicing ] See: Overhaul/Rear Suspension.
15
Brake Disc Cover Plate
16
Bolt, 10 Nm
17
Brake Disc
18
Collar Screw, 200 Nm +180°
‹› Always replace after removal.
19
Bolt, 5 Nm
20
Tie Rod
21
Bolt, 90 Nm +90°
‹› Always replace after removal.
‹› Must be tightened in the curb weight position. Refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position ] See:
Procedures/Rear Suspension.
22
Bolt, 120 Nm +360°
‹› Always replace after removal.
‹› Must be tightened in the curb weight position. Refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position ] See:
