A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
/Page-1265002.png)
‹› The ATF level is checked at the ATF inspection plug.
‹› The ATF level is correct if a small amount of fluid drips out of the inspection opening (this is normal as the fluid expands as it heats up) at an ATF
temperature between 35 °C and 45 °C (for hot countries 50 °C).
CAUTION!
There is a risk of damaging the transmission.
‹› Only use the ATF available as a replacement part for the automatic transmission 0B6.
‹› Other oils can cause malfunctions or transmission failure.
‹› Follow the allocation.
‹› The ATF filler tool must be clean and the ATF must not be mixed with any other ATF oils!
-
Fill the reservoir of the ATF filler tool (V.A.G 1924) with ATF for automatic transmission 0B6; ATF specification.
-
Secure reservoir of ATF filler tool (V.A.G 1924 ) as high as possible on vehicle.
CAUTION!
There is a risk of damaging the transmission.
‹› Engine must not be started if only a small amount or no ATF is in the transmission after repair work or after significant ATF loss.
‹› In this case, pre-filling is necessary. Refer to => [ ATF, Draining or Filling after Repair ] See: ATF, Draining or Filling after Repair.
-
Remove rear noise insulation.
