A4 Quattro Wagon V6-2.8L (AHA) (1998)
/Page-5034002.png)
-
Install on pin, item 12
8. Pin
-
Insert into clutch pedal and master cylinder
-
Lock pin in pedal (arrow)
9. Brake pedal
-
Install on pin, item 12
10. Accelerator pedal
-
Insert into pedal bracket
11. Accelerator pedal cable
-
Cable detent ball must be engaged in accelerator pedal cable mount
12. Pin
13. Locking clip
-
Always replace
-
Qty: 2
-
Install on pin, item 12
14. Cable pulley with linkage
-
TDI only
15. Hex nut
-
Always replace
-
8 Nm (71 inch lbs.)
16. Washer
17. Bolt and washer assembly
-
25 Nm (18 ft. lbs.)
-
Do not tighten in vehicle until after assembling brake servo unit
18. Vent valve
-
For Cruise Control System (CCS)
-
Adjusting
19. Brake light switch
-
Adjusting
20. Clip
-
Always replace
-
Press into pedal bracket until fully seated
21. Stop block
-
Markings determine correct installation position:
-
Manual transmission
-
HS lettering is visible
-
AG lettering faces in direction of travel
-
Automatic transmission
-
AG lettering is visible
-
HS lettering faces in direction of travel
22. Instrument panel cross member
23. Joint pin
-
Install pedal bracket onto joint pin
24. Throttle Position Sensor (TPS)
-
TDI only
25. Screw
-
8 Nm (71 inch lbs.)
