A4 Quattro Wagon V6-2.8L (AHA) (1998)
-
Disconnect 8-pin harness connector from throttle valve control module -J338-.
If measured voltage was approx. 5 volts:
-
Connect multimeter US1119 (Fluke 83 or equivalent), using adapter cables from VW1594 connector test kit.
-
Measure resistance to check for short circuit between test box sockets 62 (power supply) and 75 (signal wire).
-
Test box sockets 62 and 75
-
Specified value: Infinity Ohms
If measured voltage was approx. battery positive voltage (B+):
-
Check wiring at 8-pin connector, terminal 5 for short circuit to battery B+.
Continuation (with no measured voltage)
-
Disconnect 8-pin harness connector from throttle valve control module -J338-.
-
Check wiring for open circuit between ECM/test box and 8-pin harness connector.
-
Connector terminal 5 to ECM/test box socket 75
-
Specified value: max. 1.5 Ohms
If wiring is OK:
-
Replace throttle valve control module -J338-.
-
Carry out adaptation of throttle valve control module to ECM.
-
Check readiness code. If Diagnostic Trouble Code (DTC) memory has been erased, or ECM was disconnected, generate new readiness code.
Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/Checking Readiness Code" See: Computers and Control Systems/Testing and
Inspection
Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/Generating Readiness Code" See: Computers and Control Systems/Testing and
Inspection