A4 Quattro Wagon V6-2.8L (AHA) (1998)
Seat Belt: Service and Repair
Rear Belt Adjuster - Interior Trim, Removing and Installing
Rear Belt Adjuster, Removing And Installing
Removing
NOTE: It is not necessary to remove the rear shelf when removing the rear belt adjuster.
-
Undo lower anchoring point of rear three-point seat belt.
Tightening torque: 50 Nm (37 ft.lb)
-
Unclip belt guide cover - 3 -.
-
Detach belt adjuster cover - 2 - at left and right of retaining tab - 7 -.
-
Swing belt adjuster - 4 - with belt webbing upward.
-
Use screwdriver to press retaining tab - 1 - (2x) inward while simultaneously pulling up on belt adjuster - 2 -.
-
Pull belt webbing through belt adjuster - 2 -.
Installing
-
Make sure retaining tabs - 1 - (2x) fully engage.
-
Make sure rear lug engages in notch - 6 -.
Adjustment locking device - 5 - must point toward center of vehicle.