A4 Quattro Wagon V6-2.8L (AHA) (1998)
Installation position: larger inner diameter of wheel bearing faces wheel hub -7-
Removing refer to Fig. 4
Installing refer to Fig.5
6. Splash shield
Bolt to wheel bearing housing
7. Wheel hub
Removing refer to Fig. 6
Installing -Fig.7
Pressing off bearing inner race refer to Figs. 8 and 9.
8. Bolt 10 Nm (7 ft. lbs.)
Fig. 1 Inserting assembly device into wheel bearing housing
-
Position 3292/1 support onto bonded rubber bushing.
-
Push 3292 assembly device over 3292/1 support and move into position.
-
Tighten threaded spindle up to stop so that both jaws of 3292 assembly device are located in annular groove between bonded rubber bushing and
wheel bearing housing.
Fig. 2 Bolting cross bar onto assembly device
-
Center 3292/2 cross bar and move fully up against 3292/1 support by tightening both bolts.
-
Screw in spindle of 3292/2 cross bar until bushing is drawn out.
Fig. 3 Installing bonded rubber bushing