A4 Quattro Wagon V6-2.8L (AHA) (1998)
-
Install with angled ends pointing toward inside of mounting bracket
11- Pull rod
-
Removing and installing
12- Spring
-
Removing and installing
13- Selector lever
-
With pull rod, coil spring, selector gate and Tiptronic spring mechanism
-
Removing and installing
-
Disassembling and assembling
14- Stop buffer
-
Clip into cable lever -16-
-
Installing: larger surface faces selector lever
15- Detent
-
Clip into cable lever -16-
-
Removing and installing
16- Cable lever
-
Secured in bracket -21 with fulcrum pin -22-
17- Spring clip with roller
-
For selector gate
-
Removing and installing
18- Spring clip with roller
-
For Tiptronic gate
-
Removing and installing
19- Frame
-
Clip onto bracket
-
Install with ribbed side facing upward
20- Nut
-
10 Nm (7 ft lb)
21- Mounting bracket
-
Removing and installing
22- Fulcrum pin
-
Secures cable lever -16- in mounting bracket -21-
23- Locking pawl
-^8GFor shift lock
-
Removing and installing
24- Shift lock solenoid -N110-
-
Removing and installing
-
Disconnecting and connecting wiring
-
Can be checked by electrical test and "Read Measuring Value Block" scan tool function 08.
25- Fulcrum pin
-
For locking pawl
-
Removing and installing
26- Cover
-
With seal for mounting bracket
-
Removing and installing
27- Nut
-
10 Nm (7 ft lb)
28- Securing clip
-
Secures selector lever cable to cable lever -16-
-
Angled end faces forward
29- Locking plate
-
Secures selector lever cable to mounting bracket
-
Angled end faces inside of mounting bracket
30- Selector lever cable
-
Do not bend or kink; lightly grease cable eye and ball socket
-
Removing and installing
-
Must be replaced if rubber sleeves are damaged
-
When installing, make sure that rubber sleeve on transmission end is not twisted
-
Adjusting
31- Hex bolt
-
23 Nm (17 ft lb)
32- Support bracket
-
For mounting selector lever cable at transmission
-
Removing and installing
33- Cable tie
-
For lock cable