A4 Quattro Wagon V6-2.8L (AHA) (1998)
Assembling
-
Place coil spring -B- onto pull rod -A-.
-
Insert pull rod and coil spring in selector lever.
Installation position: rounded corner (arrow) and sharp edge point in direction of travel.
-
Check that pull rod slides freely on selector lever guides -C-
-
Lift pull rod -D- and slide selector gate -B- with Tiptronic spring into selector lever -A-.
-
Drive in mounting pin -C- with drift, illus. N37-0524.
-
To secure pin make two new punch marks (arrows), offset 901 from existing ones.
The mounting pin must not have more than 4 punch marks.
-
Install selector lever.
Removing and installing shift lock solenoid
Removing
-
Remove shift mechanism.
-
Remove stop buffer from cable lever.
-
Move selector lever into Tiptronic gate, then remove frame.
-
Move selector lever to "2" position.
-
Lift lever for lock cable, detach from mounting, and remove from mounting bracket.
-
Press out pin for locking pawl using drift.
-
Lift out shift lock solenoid together with locking pawl.
Installing
-
Move selector lever to "2" position.
-
Insert shift lock solenoid in mounting bracket from above together with locking pawl.
-
Carefully drive in pin for locking pawl.
-
Use screwdriver to make sure locking pawl is properly engaged with selector lever in "P" and "N" positions.
-
Place locking lever in mounting bracket and make sure it engages properly at both mountings.
-
Check operation of locking lever.
With the selector lever in position "P", the locking lever should engage the detent and make it impossible to change gear.
-
Place frame on mounting bracket (ribbed side upward) and insert stop buffer in cable lever.
-
Install shift mechanism.