A4 Quattro Wagon V6-2.8L (AHA) (1998)
Seals and Gaskets: Service and Repair
Oil seals for flange shafts, replacing
Special tools and equipment
-
2062 driver
-
VAG1306 drip tray
-
VAG1383A engine/transmission hoist
Removing
Rear final drive installed
-
Observe general repair noses, Refer to Automatic Transmission/ Transaxle
Note:
The exhaust system must only be removed if left seal is replaced.
-
Remove rear part of exhaust system behind clamping sleeve(s), refer to Exhaust System - Service and Repair - Procedures See: Engine,
Cooling and Exhaust/Exhaust System/Service and Repair
-
Remove left or right drive axles from rear final drive and lay to side, refer to Drive Axles, Bearings and Joints - Axle Shaft Assembly - Service
and Repair - Procedures See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair