A4 Quattro Wagon V6-3.0L (AVK) (2002)
Rear Door Panel: Locations
Rear Door Trim, Assembly Overview
Rear Door Trim, Assembly Overview
1
-
Door trim.
-
Removal
-
Unclip decorative panel -2-.
-
Remove decorative panel -2- toward front.
-
Remove bolts -3- (3x) from door trim -1-.
-
For all vehicles
-
Unclip door trim -1-. Replace damaged clips => Fig 3
-
Raise door trim -1- upward approx. 20 cm. out from door shell.
-
Disengage Bowden cable for interior door mechanism. => Fig 1
-
Disconnect electrical harness connectors. => Fig 2
-
Installing
-
When installing, speed nuts -8- (4x) for expanding nuts -7- (4x) must be clipped in.
-
When installing, door trim must be pressed in the middle to door shell.
-
When installing manual window crank, note its position.
2
-
Decorative panel
3
-
Bolts (3x)
4
-
Cover
5
-
Manual window crank
6
-
Bolt
7
-
Expanding nut (4x)
8
-
Speed nut (4x)
9
-
Window regulator switch
Fig. 1 Disengaging Bowden cable