A4 Quattro Wagon V6-3.0L (AVK) (2002)
/Page-1776001.png)
Brake Pedal Assy: Service and Repair
Brake Pedal, Assembly Overview
Brake pedal, assembly overview
WARNING: The brake pedal travel must not be shortened by additional floor coverings.
1. Dash panel cross member
2. Circlip (2 x )
^
Always replace
^
Fit onto pin
3. Pin
^
Insert into clutch pedal and brake pedal
^
Lock pin in pedal -arrow-.
4. Bracket
^
Stop plate for accelerator pedal
5. Hex socket head bolt, 10 Nm
6. Accelerator pedal module
^
Screw into pedal bracket
7. Combi bolt, 25 Nm
^
Tighten in vehicle after brake servo unit has been installed
8. Brake light switch
9. Clutch switch
10. Phillips-head bolts, 5 Nm
^
Must engage in recess of pin (Item 3 )
^
Do not tighten the bolt until the retaining washers (Item 2 ) have been installed.
11. Combi bolt, 20 Nm
^
Always replace
12. Brake pedal
^
Push in the pin
^
Audibly engage the brake pedal in the brake servo
13. Master cylinder
