A4 Quattro Wagon V6-3.0L (AVK) (2002)
/Page-774003.png)
^
Disconnect exhaust system at left double clamp (left arrow).
^
Remove heat shield -1- for left drive axle.
^
Remove bracket for front exhaust pipe (arrow).
^
Expose oxygen sensor wires.
^
Remove nuts -1- and -3- for front exhaust pipehaust manifold which are accessible from bottom.
Note: Illustration is shown with engine removed.
^
Remove front exhaust pipe with catalytic converter.
Installing
Installation is reverse of removal:
Note:
-
All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
-
Oxygen sensor wiring must always be secured in the same position when installing so that contact with the exhaust pipe is avoided.
-
Replace gaskets and self-locking nuts.
^
Install exhaust system free of stress.
