A4 Quattro Wagon V6-3.0L (AVK) (2002)
/Page-2051002.png)
-
Fold back half the length of bare metal part.
-
Strip end of 0.5 square mm wire (approx. 6-7 mm) using wire stripper.
-
Push crimp connector over wire ends and crimp on both sides using stop pliers.
The insulation on the connector ends may not be crimped.
-
Make sure that the correct red crimping slot for 0.5 square mm is used.
-
After crimping, crimp connector must be shrunk using hot air blower.
The crimp connector must be heated from the center towards both ends until it is completely sealed and the adhesive oozes out.
The hot-air blower must be set to the appropriate temperature in accordance with its operating instructions.
While shrinking, make sure that no other connectors, plastic parts or insulating material is damaged by the hot air jet.
-
If repair connector was previously taped, this area must be taped again with yellow insulation tape. If necessary, secure wiring with new tie wraps.
