A4 Quattro Wagon V6-3.0L (AVK) (2002)
Fuel Level Sender 2 -G169- Installing
-
Install new fuel level sender seal.
^
Install seal dry (do not lubricate) into fuel tank opening.
-
Install new Fuel Level Sender 2 -G169- (Part No. 8E0 201 317N).
^
Observe installation position of flange lug -2- must be between tabs -1- and -3-on fuel tank (see illustration).
-
Tighten locking ring using wrench for fuel tank sender unit 3087.
^
Torque = 145 Nm (106 ft. lbs.)
-
Reconnect fuel line and electrical connector on top of Fuel Level Sender 2 -G169- and reinstall sender cover.
-
Reconnect battery (observe safety precautions see Repair Manual, Electrical Equipment, Repair Group 27).
-
After reconnecting vehicle battery, re-code and check operation of anti-theft radio. Also check operation of clock and power windows according to
Repair Manual and/or Owner's Manual.
-
Replace fuel removed from fuel tank.
When procedure applies to vehicles within the New Vehicle Limited Warranty, use the table shown.