A4 Quattro Wagon V6-3.0L (AVK) (2002)
Control Module HVAC: Service and Repair
Control Module, Fresh Air Blower -J126- & -V2- Remove & Install
Control Module For Fresh Air Blower -J126- And Fresh Air Blower -V2-, Removing And Installing
Removing
-
Remove glove compartment:
-
Disconnect connector -A-.
-
Remove lower A-pillar trim.
-
Loosen cable tie -B-.
-
Tilt carpet carefully toward back.
-
Press sound insulation mat aside, until rear screw -C- is reachable.
-
Unscrew bolts -C-.
-
Press sound insulation mat aside and pull fresh air blower -D- out of air conditioner.
NOTE:
-
The Control module for fresh air blower -J126- is integrated in the Fresh Air Blower -V2-, and cannot be replaced separately.
-
Observe correct seating position when installing the fresh air blower into the air conditioner.
Installing
Installation is the reverse of removal.