A4 Quattro Wagon V6-3.0L (AVK) (2002)
Seat Belt Tensioner: Locations
Rear Three-Point Seat Belt, Assembly Overview
Rear Three-point Seat Belt, Assembly Overview
1
-
Belt module/belt tensioner
-
Removal - Sedan:
-
Remove top C-pillar trim.
-
Remove rear shelf.
-
Remove damming piece beneath rear shelf.
-
Remove side trim luggage compartment.
-
Removal - Avant:
-
Remove side trim luggage compartment.
-
All:
-
Remove bolt -2- accessible from below on belt module/belt tensioner from luggage compartment
-
Remove bolt -5- on outer attachment point for seat (eyelets on belt end).
-
To disconnect harness connector -7-, open fuse using a screwdriver (USA).
-
Remove cable with clip.
-
Installing
-
When installing belt module -1-, ensure that bolt -2- is engaged in the small diameter catch hole -3-.
-
Ensure that the noise protection cover -8- is seated properly on belt module -1-.
-
Ensure that the belt tensioner wire -4- is clipped in and not lying in the belt area.
-
Ensure that connector -7- (USA) engages properly.
-
Complete installation in reverse order of removal.
2
-
Bolt
-
Tightening torque: 55 Nm
3
-
Belt module/belt tensioner catch holes
4
-
Belt tensioner wire with clip
5
-
Bolt
-
Tightening torque: 55 Nm
6
-
Seat belt