A4 Quattro Wagon V6-3.0L (AVK) (2002)
Vehicles with 6-cylinder engine
-
Install the front exhaust pipe and adjust the exhaust system so that it is free of tension.
-
Install the front crossbrace, if applicable.
-
Install the left drive axle heat shield.
All Vehicles
-
If the pipe/hose line on the clutch slave cylinder was disconnected, the clutch system must be bled after the slave cylinder is installed again.
Tightening Specifications
Clutch slave cylinder to transmission (replace bolt) ..................................................................................................................................................... 23Nm
Transmission shift lever to selector shaft (Replace nut) ............................................................................................................................................... 20Nm
Heat shield for drive axle to transmission .................................................................................................................................................................... 23Nm