A4 Quattro Wagon V6-3.0L (AVK) (2002)
12 - O-ring
^
Always replace
13 - Intermediate piece
14 - Ball stud
^
Lubricate with MoS2-grease
^
On aluminum transmissions tighten to 25 Nm
Fig. 1 Separating slave cylinder from hose and line assembly
Removing
-
Use a screwdriver to remove hose and line assembly, pry out clip -A- up to stop. Then pulled out the hose and line assembly.
Installing
-
Press in clip -A- up to stop
-
Insert hose and line assembly into slave cylinder until it is heard to engage.
-
Test by pulling on hose and line assembly.