A4 Quattro Wagon V6-3.0L (AVK) (2002)
/Page-1574005.png)
-
Press in drive flange.
-
Fit circlip onto drive flange.
-
Lightly oil O-ring and fit into bearing housing groove.
-
Insert spring plate and shims into bearing housing.
Installation position:
-
Slide coil spring onto drive flange.
-
Tighten securing bolts for bearing housing in diagonal sequence and in stages to 25 Nm.
-
Bolt on driveshaft, Refer to Drive/Propeller Shaft, Service and Repair
-
Top up oil in transmission and check oil level.
