A4 Quattro Wagon V6-3.0L (AVK) (2002)
Fig. 9 Pulling in outer race for large taper roller bearing
-
Lightly lubricate the bearing seat in the housing.
-
Insert predetermined shim 'S3" for drive pinion .
-
The inscription "top" on the pressure plate 3253/4 faces the nut of the insertion device
Fig. 10 Pressing in small taper roller bearing outer race
-
Lightly lubricate the bearing seat in the housing.
-
The outer race must be attached with drift VW 295 and thrust plate 30205.
Fig. 11 Pressing on small taper roller bearing inner race
-
Insert the new drive pinion with a new spacer sleeve.
WARNING!: Wear protective gloves!
-
Heat inner race for small taper roller bearing to approximately 100°C and install onto drive pinion.
-
Press up drive pinion and insert bearing with thrust plate 40-21 onto stop.