A4 Quattro Wagon V6-3.2L (BKH) (2005)
/Page-4862004.png)
-
Set up special tools with hydro-bushing on subframe as illustrated
Ensure correct position when attaching support T40033/6.
1 - Nut T40034/1 or T40034/2
2 - Support T40033/6
3 - Hydro-bushing
4 - Thrust piece T40033/5
5 - Hollow piston cylinder HKZ-15
6 - Thrust piece E-5
7 - Special nut E-8-214
8 - Assembly tool T40034
9 - Subframe
-
Pretension special tools with hydro-bushing.
-
Coat complete surface of hydro-bushing using assembly lubricating oil G 294 421 A1 diluted 1:100 with water.
-
Make sure that the ends of the rubber beads of the hydro-bushing - 1 - line up with the markings - arrows B and C - on subframe - 2 -.
- Arrow A - direction of travel
-
Press in hydro-bushing as far as stop by operating pump.
Note:
^
When pulling in the hydro-bushing using wheel bearing tool V.A.G 1459 B, the tool must be repositioned during installation.
^
Make sure that the hydro-bushing remains straight during the first stage of installation, otherwise the outer ling may be damaged.
-
Lift subframe using engine/transmission jack V.A.G 1383 A.
-
Install and tighten new subframe bolts with new washers and (front wheel drive), or and (all wheel drive).
Rear hydro-bushings only
-
Install stabilizer bar.
