A4 Quattro Wagon V6-3.2L (BKH) (2005)
/Page-5072003.png)
-
Lay plastic film - 1 - over Velcro strips - 4 - on lumbar support. Secure plastic film on lumbar support.
-
Ensure lumbar support is attached to lumbar support frame with assembly fastener - 5 - or a suitable screw.
-
Position four-way lumbar support frame behind backrest frame and engage top of frame - 3 - in mounts on backrest frame at left and right with
springs - 2 -.
-
Before securing rivet - 4 -, a plastic washer - 1 - must be placed between lumbar support - 2 - and backrest frame - 3 -.
-
Rivet lumbar support frame - 2 - with backrest frame - 3 -.
-
Remove plastic film between backrest padding and lumbar support.
-
Press lumbar support Velcro fastener onto backrest padding to secure.
-
Connect electrical connectors at curvature and height adjustment motors.
Further installation is performed in the reverse order of removal. Observe the following when doing so:
CAUTION: Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically
discharge". This can be done by touching door striker, for example.
NOTE: Ensure that electrical connections are pushed in as far as stop and engage with a click.
-
Switch on ignition.
CAUTION: Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired
correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the
battery.
-
Connect battery with ignition on, procedure.
-
If Airbag Malfunction Indicator Lamp (MIL) K75 indicates a fault after installation, DTC memory must be checked, deleted and checked again.
