A4 Quattro Wagon V6-3.2L (BKH) (2005)
-
Secure balance weight - 2 - at rear of engine with a drill bit 8 mm dia. - Pos. 1 -.
-
Remove bolt - 3 - and remove balance weight from balance shaft.
-
Remove bolt - 2 -, thereby counter-hold balance weight with drift and remove balance weight - 1 - from balance shaft at front of engine.
-
Remove bolts - arrows - and remove bearing end bracket from balance shaft at rear of engine.
-
Pull balance shaft rearward and out from cylinder block.
Installing
^
Secure crankshaft - 1 - in TDC position using crankshaft holder T40069.
Installation is in reverse order of removal. Note the following: