audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Test Chart 1|Page 4243 > < Test Chart 1|Page 4241
Page 3
background image

-

Connect contact - 4 - to vehicle ground (GND) using a jumper cable from connector test set V.A.G 1594 C .

-

Connect alligator clip to vehicle battery (+).

-

Remove fuel filler cap from fuel filler tube.

-

Remove rear engine cover - arrows - .

CAUTION:  The fuel system is under pressure! Before opening system, place rags around the connection area. Then release pressure by
carefully loosening the connection.

-

Disconnect fuel line - arrow -.

-

Connect pressure gauge V.A.G 1318 to fuel line using adapter V.A.G 1318/11 and V.A.G 1318/12 .

-

Connect extension hose - arrow - to pressure gauge and hold it in a measuring container.

-

Open pressure gauge shut-off valve. The lever points in direction of flow.

-

Generate pressure in fuel system by pressing switch of remote control and slowly closing shut-off valve of pressure gauge.
-

Specification: 4 bar positive pressure.

-

From this point on do not move position of shut-off valve.

-

Empty measuring container.

-

Press switch on remote control for 15 seconds.

Test Chart 1|Page 4243 > < Test Chart 1|Page 4241