A4 Quattro Wagon V6-3.2L (BKH) (2005)
Control Module HVAC: Service and Repair
Fresh Air Blower Control Module J126 And Fresh Air Blower V2, Removing And Installing
Removing
-
Remove glove compartment.
-
Disconnect connector - A -.
-
Remove lower "A-pillar" trim.
-
Loosen cable ties - B -.
-
Remove bolts - A -.
-
Pull air conditioner slightly to rear.
-
Carefully fold back floor covering.
-
Press noise insulation mat aside until rear bolt - C - is accessible.
-
Remove bolts - C -.
-
Push noise insulation mat aside and pull Fresh Air Blower V2 -D - out of air conditioner.
NOTE:
-
The Fresh Air Blower V2 contains the Fresh Air Blower Control Module J126 as an integral component which cannot be replaced separately.
-
When installing, pay attention to correct positioning of Fresh Air Blower V2 in air conditioner.
Installing