audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Headlamp Control Module|Locations > < Lighting - DTC 01771/Headlamp Range Control Warning|Page 15971
Page 2
background image

^

Check suffix following software part number (arrow).

^

If software level suffix is already "E", DO NOT continue with this bulletin. Update - Programming is rot necessary. Further diagnosis is required for
condition.

^

If the hardware part number is 4F0 907 357 or 4F0 907 357A the module cannot be flashed and must be replaced. DO NOT continue with this
bulletin.

^

If software level suffix is "C", perform Update - Programming procedure as follows:

Update - Programming procedure, performing

^

Select Vehicle Self Diagnosis >> 55 - Automatic vertical headlight aim control >> Update Programming (Update CD 4F0 906 961 N must be in the
disk drive of the diagnostic tester).

^

After the forward arrow is pressed the Software will begin to load. DO NOT interrupt vehicle or tester during process.

^

After several minutes, download is complete and the ignition must be cycled. There will be DTC's for "Control unit not coded" and "no or incorrect
basic setting". Exit Vehicle Self Diagnosis mode. 

Update - Programming procedure, performing coding and basic settings.

^

Select Guided Functions >> 55 - Dynamic Headlight Range Control with AFS >> J431 - Headlight Range Ctrl. Mo. coding to code the module and
perform basic settings.

Warranty

Required Parts and Tools

Update CD Part/Literature No: 4F0 906 961 N (Indicated on CD).

Tip: 

Update CD Part / Literature No: 4F0 906 961 N has been provided to dealers free of charge with Audi Technical Bulletin 96-05-01 "Engine Does Not
Start / Intermittent No Start Using Advance Key Start Button, Starts w/Key & Ignition Switch".

Additional copies of the Update CD may be ordered from the Audi Technical Literature Ordering Center at www.audi.ddsltd.com, or by calling
1-800-544-8021 from 8:00 a.m. to 8:00 p.m. EST Monday through Friday.  This number can be dialed in both the United States and Canada.

All part and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Dept. and service manuals for
the latest information.

Headlamp Control Module|Locations > < Lighting - DTC 01771/Headlamp Range Control Warning|Page 15971