A4 Quattro Wagon V6-3.2L (BKH) (2005)
/Page-1135004.png)
-
Install new seal on ATF inspection plug and tighten to 80 Nm. The ATF check is now completed.
-
End function "08 - Read data block (measured value block)" by touching <- key.
-
Press "06 - End output".
-
Switch off ignition and disconnect diagnostic connector.
Filling up ATF
If no ATF emerges from ATF inspection hole when ATF has reached 40°C, top off with ATF.
Note:
-
The ATF inspection plug must be screwed in again at the latest when ATF temperature reaches 45°C (or 50°C in hot climates). If necessary,
switch off the engine, allow transmission to cool down and repeat the test.
-
Guide filler nozzle of ATF charging device V.A. G 1924 in from below through an opening in deflector cap - arrow -, taking care not to push
deflector cap upward out of position.
-
Fill with ATF using ATF charging device V.A.G 1924 until ATF comes out of inspection hole.
Note:
^
The ATF level must not be too low or too high, otherwise this would impair the function of the transmission.
-
Install new seal on ATF inspection plug and tighten to 80 Nm.
-
End function "08 - Read data block (measured value block)" by touching, <- key.
-
Press "06 - End output".
-
Switch off ignition and disconnect diagnostic connector.
