A4 Quattro Wagon V6-3.2L (BKH) (2005)
/Page-2768002.png)
-
Remove bolts on final drive cover in sequence - 11 to 1 - and remove cover together with outer race for tapered roller bearing and shim.
Note:
^
Thickness of shim has been measured to fit, the shim must not be replaced with another shim of different thickness.
-
Remove differential.
-
Remove tapered roller bearing outer race - 1 - for differential and shim - 2 - (behind outer race) from transmission housing by hand.
Note:
^
Thickness of shim has been measured to fit, the shim must not be replaced with another shim of different thickness.
-
Remove flange shaft (left-side).
-
Remove seal.
Note:
^
The oil seal extractor lever VW 681 must be applied behind the two sealing lips of the oil seal. Do not apply the lever to the outer
circumference of the seal, as this would damage the sealing surface in the transmission. Guide the lever carefully when removing the seal.
-
Examine oil seal seat in transmission housing for damage; reface surface if necessary.
-
Lightly lubricate outer circumference and sealing lip of oil seal with gear oil.
Note:
^
Push the seal onto the thrust piece with the protruding sealing lip of the seal facing the tool.
