A4 Quattro Wagon V6-3.2L (BKH) (2005)
Shift Interlock Cable: Adjustments
Locking cable, adjusting, 09L, 6 Spd. A/T AWD
Special tools, testers and auxiliary items required
^
Adjustment pin for shift lock 3 3352 A
^
Angle grinder
^
Safety goggles
Preparation
Note:
^
If the procedure described below is followed the center console does not have to be removed.
-
Using an angle grinder or similar, cut off Adjustment pin for shift lock 3 3352 A at rear end of flat section - arrow
CAUTION: Wear safety goggles.
-
Order a new Adjustment pin for shift lock 3 3352 A as a replacement for subsequent use.
Requirements for adjustment
^
Locking cable must be in installation position.
^
Selector lever is in position "P".
^
Ignition key is in removal position.
Procedure
-
Remove trim panel from center console.
Note:
^
The selector lever handle and cover can remain installed.
-
Remove ashtray from center console.