A4 Quattro Wagon V6-3.2L (BKH) (2005)
/Page-2904002.png)
A. If the complaint occurs in D and MVB10/1 is above 380 mA replace only the 4 axial seals (01J301547F, as shown in Figure 1, A) at the valve body.
B. If the complaint occurs in R replace all 4 axial seals (01J301547F, as shown in Figure 1, A) at the valve body, and the axial seal in the input shaft area
(01J301547F, as shown in Figure 2.)
Refer to Repair Manual Group 37 and Group 38 for repair procedures.
If the conditions/measured values listed above do not apply, contact the Technical Assistance Center.
