A4 Quattro Wagon V6-3.2L (BKH) (2005)
/Page-2939004.png)
removing the drive shaft. Otherwise there is a danger that the new bolts will seize when they are screwed in and then shear if they have to removed
later.
^
The threaded holes can be cleaned with a thread tap.
^
Replace drive shaft bolts (self-locking).
-
Install drive shaft and attach bolts for constant velocity joint.
-
Screw in securing bolts -arrows- for center bearing hand-tight.
-
Screw in bolt -3- M10 x 100 into rear final drive.
-
To tighten bolts -1- of the rear and front drive shaft, counterhold with an assembly lever -2-.
-
Remove assembly device 3139
-
Remove securing bolts -arrows- for the center bearing. The drive shaft must be supported manually by a second mechanic.
Note: When removing the securing bolts support the drive shaft by hand.
