A4 Sedan L4-1.8L Turbo (AEB) (1997)
Fluid - M/T: Testing and Inspection
Transmission Oil Level, Checking
Special tools and equipment
-
17 mm wrench insert hex socket
or
-
3357 triple square socket driver
Notes:
-
Vehicle must be level when checking transmission oil level. This can be achieved using a pit or 4-post lift.
-
The oil filler plug is on left side of the transmission underneath the engine speed (RPM) sensor, and may be concealed by a heat shield over the
drive axle.
-
Depending on the version installed, use either 3357 triple square socket driver or a 17 mm hex socket to loosen the oil drain plug.
- To check oil level, remove oil filler plug (arrow).
- Check oil level with hand-made tool, e.g. bent wire.
-
Specification: oil 7 mm (0.276 inch) below bottom of filler hole.
Note:
-
Service Technicians may fill oil up to bottom of oil filler hole.
- Top off transmission oil if necessary, See: Specifications/Capacity Specifications
- Install oil filler plug.
-
Tightening torque: 25 Nm (18 ft. lbs.).