audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Fuel Pump > < Fuel Pressure Regulator|Testing and Inspection
Page 2
background image

-

Start engine and let run at idle.

-

Measure fuel pressure.
Specified value: approx. 3.5 bar (50 psi)

-

Disconnect vacuum hose (arrow) for fuel pressure regulator.
Fuel pressure must increase to approximately 4.0 bar (58 psi)

-

Reconnect vacuum hose.

-

Switch ignition off.

-

Check for residual fuel pressure by monitoring decrease in pressure on gauge. Specified value:
After 10 minutes: at least 2.5 bar (36 psi)

If residual pressure drops below 2.5 bar (36 psi):

-

Start engine and let run at idle.

-

After pressure has built up, at the same time:

 

-

Switch ignition off.

 

-

Close valve on pressure tester VAG 1318-lever in OFF position (arrow).

-

Monitor decrease in pressure on gauge.

If residual pressure still drops below 2.5 bar (36 psi), possible malfunctions are:

-

Leaking connection between pressure tester and fuel line

-

Leaking connection between fuel supply line and fuel rail

-

Faulty check valve in fuel pump; removing and installing:

If residual pressure no longer drops below 2.5 bar (36 psi), the possible malfunctions are:

-

Leaking fuel pressure tester connections after shut-off valve.

-

Faulty fuel pressure regulator

-

Leaking fuel injectors

NOTE:  When disconnecting the pressure tester, close the shut-off valve, disconnect adapter VAG 1328/12, then catch excess fuel in a container by
opening the shut-off valve.

Fuel Pump > < Fuel Pressure Regulator|Testing and Inspection