audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Charge Air Cooler <--> [Intercooler]|Service and Repair > < Charge Air Pressure Sensor-G31, Checking|Page 8840
Page 1
background image

Charge Air Cooler: Testing and Inspection
Charge Pressure Bypass Valve, Checking

Charge pressure bypass valve, checking 

Note: 
^

The charge pressure bypass valve is located in front of the turbocharger. It is opened by vacuum during deceleration and when under partial load at
idle. This reduces boost pressure in front of the throttle valve and keeps the turbocharger spinning at higher RPMs.

^

Check the charge pressure bypass valve if experiencing reduced performance or turbo lag.

Special tools and equipment 
VAG1390 hand vacuum pump

^

Connect VAG1390 hand vacuum pump to vacuum connection on recirculation valve.

^

Operate hand vacuum pump.

^

Recirculation valve must open (arrow).

^

After approximately 30 seconds, operate vent valve on hand vacuum pump.

^

Recirculation valve must close (arrow).

If valve does not open/close or valve plate does not seal correctly when valve is closed:
^

Replace valve and secure recirculation shut off valve connections using hose clamps.

Charge Air Cooler <--> [Intercooler]|Service and Repair > < Charge Air Pressure Sensor-G31, Checking|Page 8840