A4 Sedan L4-1.8L Turbo (AEB) (1997)
-
10 Nm (7 ft. lbs.)
5. Brake splash guard
6. ABS wheel speed sensor
-
Pull out to remove
-
Install drive axle before installing speed sensor
-
Press into clamping sleeve up to stop
-
Routing wiring, Refer to Brakes and Traction Control.
7. Clamping sleeve
-
Always replace
-
Left and right sides identical
-
Before installing, lubricate hole in wheel bearing housing with brake cylinder paste
-
Press into wheel bearing housing up to stop
Special tools, test equipment and auxiliary items
Fig. 1 Pressing wheel hub out of 75 mm diameter wheel bearing housing