A4 Sedan L4-1.8L Turbo (AEB) (1997)
/Page-4231004.png)
-
Insert both upper control links into wheel bearing housing and tighten new nut -2-.
-
Tightening torque: 40 Nm (30 ft. lbs.)
-
Upper link joint with collar must be pushed onto wheel bearing housing as far as possible when installing.
-
Tighten nut at ball joint.
-
Tightening torque: 100 Nm (74 ft. lbs.)
-
If necessary, counterhold ball joint using 4 mm hex wrench
-
Insert ABS wheel speed sensor wire into holder at brake caliper.
-
Install new nuts for both suspension struts and tighten to 20 Nm (15 ft. lbs.).
CAUTION: Be careful not to damage the surface of the brake lines.
-
Re-install rubber grommets into plenum chamber.
-
Install wheel and tighten bolts to 120 Nm (89 ft. lbs.).
