A4 Sedan L4-1.8L Turbo (AEB) (1997)
Pressure Plate: Service and Repair
Clutch, Servicing
Centering clutch plate and removing and installing pressure plate
Special tools and equipment
- 3067 flywheel retainer
- 3176 centering mandrel
Position of clutch plate: spring pack (coil springs) or marking "Getriebeseite" facing pressure plate and transmission.
-
When installing on 2.8 Liter 5V 142 kW engine (or 2.8 Liter 128 kW engine if installed), make sure white color marking on dual-mass flywheel
lines up with white color marking on pressure plate when assembling.
Clutch lining and contact surface of pressure plate must make full contact with flywheel before bolts are inserted.
-
Loosen and tighten bolts in stages and in diagonal sequence.
-
Final tightening torque: 22 Nm (16 ft. lbs.).
-
Reverse position of 3067 flywheel retainer when removing.
-
Use 3176 centering mandrel to center clutch plate.