audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Oil Pick Up/Strainer > < Wiring Diagram Layout|Page 3488
Page 2
background image

^

Remove oil pressure switch and screw in oil pressure tester VAG 1342.

^

Thread oil pressure switch -2- into VAG 1342.

^

Connect brown wire -1- of tester to Ground

^

Connect voltage tester VAG 1527 B to oil pressure switch and positive side of battery using test leads from VAG 1594 A.
-

Test lamp should not light up.

^

If test lamp lights up, install new oil pressure switch.

^

Start engine.

Note:  The switching point of the oil pressure switch can be reached when the engine is cranked on the starter motor, so watch the tester and the
test lamp while starting the engine.

Black oil pressure switch: 
^

LED must light up at 1.2 to 1.6 bar. 

^

If test lamp does not light up, install new oil pressure switch.

Check oil pressure 
^

Disconnect wire from oil pressure switch.

^

Remove oil pressure switch and screw in oil pressure tester VAG 1342.

^

Thread oil pressure switch -2- into VAG 1342.

^

Start engine (engine oil temperature approximately 80°C).
-

Oil pressure at idling speed: at least 1.3 bar 

-

Oil pressure at 2000 rpm: 3.5 to 4.5 bar 

If specified values are not attained:
^

Pressure relief valve or oil pump faulty, replace oil pump.

Oil Pick Up/Strainer > < Wiring Diagram Layout|Page 3488