A4 Sedan L4-1.8L Turbo (AWM) (2001)
-
Press ends of locking clip -B- together and remove.
-
Remove securing plate -A- for selector lever cable at shift mechanism downward.
-
Remove selector lever cable from selector lever.
from top:
-
Unclip locking cable from securing spring at shift mechanism housing, slightly lift up securing spring to do so.
-
Remove nuts (4 pieces).
from below:
-
Remove shift mechanism housing downward.
-
Pull selector lever cable out of shift mechanism at the same time, and do not bend.
Installing
-
Installation is the reverse order of removal.
In addition, the following test steps must be performed and observed.
Selector lever and lever/shift rod in position "P" (park lock must engage).
-
Raise vehicle.
-
Guide selector lever cable into shift mechanism.
-
Do not bend selector lever cable.
-
Mount shift mechanism on chassis.
-
Tighten nuts (4 pieces) to 10 Nm from top.
-
Secure boot of selector lever cable to shift mechanism cover.
-
Installing and adjusting locking cable, Refer to Shift Cable, At, Adjustments.
-
Connect selector lever cable to selector lever.
-
Install securing plate -A- for selector lever cable to shift mechanism.
Installation position:
Angled end of securing plate points toward the end of the selector lever cable.
-
Press ends of locking clip -B- together and slide onto the end of the selector lever cable.
-
Attach cover.