A4 Sedan L4-1.8L Turbo (AWM) (2001)
11. Bolt - 6 Nm (53 inch lb)
12. Transmission Vehicle Speed Sensor (VSS) -G38-
Removing and installing, refer to Transmission Speed Sensor, A/T - Service and Repair - Procedures See: Sensors and Switches -
A/T/Transmission Speed Sensor/Service and Repair
13. Spacer sleeve
Height: 8mm
14. Inner oil line
Always replace
Removing and installing, refer to Fluid Line/Hose, A/T - Service and Repair - Procedures See: Fluid Line/Hose/Service and Repair
15. O-ring
Always replace
16. Speedometer Vehicle Speed Sensor (VSS) -G22-
Removing and installing, refer to Powertrain Management - Computers and Control Systems - Vehicle Speed Sensor - Service and Repair -
Procedures See: Powertrain Management/Computers and Control Systems/Sensors and Switches - Computers and Control Systems/Vehicle
Speed Sensor/Service and Repair
17. O-ring
Always replace
Coat with Vaseline
18. Multi-Function Transmission Range Switch (TR) -F125-
Removing and installing Transmission Position Switch/Sensor, A/T - Service and Repair - Procedures See: Sensors and Switches -
A/T/Transmission Position Switch/Sensor/Service and Repair
Replacing shift rod sealing ring See: Seals and Gaskets/Service and Repair/Shift Rod Seal, Replacing
19. Bolt - 8 Nm (70 inch lb)
20. O-ring
Always replace
21. Locking clamp
22. Wiring harness
Always replace
Transmission Fluid Temperature Sensor -G93- integrated in wiring harness
Remove and install valve body to install See: Valve Body, Removing and Installing
Unhook from bracket for wiring harness -item 10-
Installtion position wiring harness connector: flat part of rear collar points toward oil pan, the tabs at collar are horizontal
23. Bolt - 6 Nm (53 inch lb)
24. Transmission Input Speed Sensor -G182-
Removing and installing, refer to Transmission Speed Sensor, A/T - Service and Repair - Procedures See: Sensors and Switches -
A/T/Transmission Speed Sensor/Service and Repair
25. Spacer sleeve
Height: 20 mm
26. Bolt - 6 Nm (53 inch lb)
27. Bracket for solenoid valve
28. Solenoid Valve 4 -N91-
With O-ring
Remove and install valve body to install See: Valve Body, Removing and Installing
29. Solenoid Valve 3 -N90-
Without O-ring
Remove and install oil pan to replace See: Oil Pan, Removing and Installing
30. Solenoid Valve 2 -N89-