A4 Sedan L4-1.8L Turbo (AWM) (2001)
/Page-3103003.png)
-
Tighten line fitting -B- to clutch master cylinder to 15 Nm (11 ft. lbs.).
-
Slide hose -A- onto brake fluid reservoir up to stop.
-
Bleed hydraulic clutch system after installing clutch master cylinder, See: Service and Repair/Clutch System Bleeding
-
To install E-box in plenum chamber:
-
Always replace seal -C-.
-
Make sure seal is positioned properly, and does not cover opening or stepped metal edge.
-
Install E-box into mounting point-Be.
-
Tighten nuts -A- to 4 Nm (35 inch lbs.).
-
Install cap and hand tighten in diagonal sequence to 4 Nm (35 inch lbs.) = imprint on E-box cover.
